ZALMAN CNPS7000B User Manual - page 7
※
The specifications of any product may change without prior notice to improve performance.
6
1) Fasten Nipples
Place a big washer on the motherboard. Then, put a nipple over it and fasten the nipple until the
motherboard is firmly stuck to the backplate.
* Retention Guide is not needed when installing CNPS7000B on Socket 754/939/940.
3) Insert Bolts
Insert the two bolts into the outer holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the
bolts in slightly, and then tighten them in an alternating
fashion until the nipples are completely pressed against
the clip.
9. Installation (AMD Sempron / AMD64 - 754/939/940)
Bolt
Outer Hole
Clip
FHS
Nipple
5) Supply Power (Connect FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
Backplate
Nipple
Motherboard
Big Washer
2) Apply Thermal Grease
Clean off particles and residue and then spread the
included thermal grease thinly and evenly over the
CPU that touches the FHS surface.
CPU (Lid)
Thermal Grease