English version.
Installation notes 1. Do not place the unit in dusty or humid conditions, under direct sunlight, or near a heat source such as a room heater. 2. Do not drop or subject the unit to excessive force. 3. Check the cpu socket compatibility before installation. 4. Do not mix any contaminants with the cool...
1) cpu water block (zm-wb5) the cpu water block incorporates a pure copper base for excellent heat transfer. The water block cover has been anodized to prevent corrosion. It supports intel ’ s socket 775 cpus and amd ’ s socket 754/939/940/am2 cpus, and is designed to be light weight and easy to ins...
3. Installation overview reserator xt reserator xt 2.1 reserator xt (reservoir+radiator+water pump) 1) weight : 7kg 2) materials : anodized pure aluminum 3) dimensions : 350(l) x 210(w) x 180(h)mm 4) maximum coolant capacity : max. 1.25 ℓ 5) integrated water pump : 6w, dc 12v, 300l/hr 6) maximum lif...
5.1 reserator placement the reserator ’ s placement should be determined in relation to the position of the pc. Place it upright, next to or slightly above the pc. Note that if the reserator is placed lower than the pc, the pvc tube ’ s internal air pressure may prevent proper initial operation. 5.2...
Reserator xt reserator xt 5.3 reserator xt ’ s coolant circulation 1) the purpose of connecting the jump cable of the power supply ’ s main connector (20p/24p) is to receive direct current (12v) needed for the test run and leakage inspection. 2) for smooth initial degassing, connect one end of the d...
5.7 dc power cable connection 1) fit the dc cable ’ s cord bushing into the groove of the i/o bracket, and fasten the i/o bracket with a bolt. 2) connect the dc cable connector to the 4-pin connector of the power supply. Note 1) do not exert excessive force when connecting the connector. Slowly conn...
5.8 confirmation of proper installation 1) check if the product is placed properly. 2) check if the coolant ’ s circulation path conforms to the path shown below. 3) slightly tug on the pvc tubes connected to each fitting to check for loose connections. 5. 9 leakage inspection and test run 1) check ...
◈ front panel display ① fan speed gage - displays the fan speed(rpm). If there is a problem, the display will flicker. If the flickering is observed, please check if there are any mechanical or pump related problems. ② fnd(flexible numeric display) display - temperature display coolant temperature(u...
Heatpipe cooled modular power supply reserator xt zalman noise prevention system gaming pc enclosures - reduction in the pfc circuitry ’ s switching fet heat generation by use of 3 parallel switching fets (normally 1 or 2 used) - heatpipe cooling system on the main rectifier (output) diodes for maxi...
