ZALMAN RESERATOR2 Installation And Operational Manual - page 13

13

English

RESERATOR 2

※

The specifications of any product may change without prior notice to improve performance.

5. 13 Confirm Proper Installation

1) Check that the product is placed properly.

2) Confirm that the coolant circulation path is correct as shown below.

3) Lightly tug the PVC tube connected to each of the fittings to check for loose ends. 

5. 14 Leakage Inspecting and Test Run

1) Supply power to the Reserator’s AC cable, and check to see if the green wire terminal

and the black wire terminal of the power supply’s main connector are connected to each

other with Jump Cable.  

2) Check the amount of coolant inside the Reserator’s Reservoir, and fill it by approximately 70%. 

3) Connect the power supply’s 4-Pin connector to the Reserator’s DC cable connector, 

and provide power for the Power Supply by switching its ON/OFF button to ON. 

4) Once the power is supplied, check to see if the flow indicator's impeller placed inside the

Reserator’s front panel is rotating, if the Blue LED is lit, and if the coolant is being circulated

to each water block. 

Reserator OUT

CPU Water Block

N/B Water Block

VGA Water Block

RAM Water Block

Reserator IN

Flow Indicator

Heat Sink

Radiate 

Heat

Absorb 

Heat

Water Pump

CPU Water Block

VGA Water Block

VGA RAM Water Block

5. 12 Installing the VGA RAM Water Block

1)  To  install  the  VGA  RAM  Water  Block,  connect  as  shown  in  the  diagram  below. 

2) Remember to install Tube Clamps on the PVC Tubes during installation.