ZALMAN RESERATOR2 Installation And Operational Manual - page 2
RESERATOR 2
2
※
The specifications of any product may change without prior notice to improve performance.
1. Make sure that the power source’s output voltage and frequency are compatible with
the power input requirements of the water pump before installing (input voltage and
frequency of the water pump are shown on the box).
2. Do not place in dusty or humid conditions, under direct sunlight, or near a heat source
such as a room heater.
3. Do not drop or subject it to excessive force.
4. CPU socket compatibility must be checked.
5. Familiarize yourself with this manual.
6. Do not mix any contaminant with the coolant when filling, for it may cause product failure.
7. Check for leaks on Water Blocks before installation.
Installation Notes
1. Reserator 2 simultaneously operates with the PC. The power must first be supplied to
the AC power cable before turning on the PC because it uses an AC pump.
2. Place the Reserator 2 and the PC body at the same location for use.
3. If the coolant isn’t circulating properly, or if the pump flux becomes too low, then the
red blinkers will flash as well as warning sound. In this case, turn the PC OFF immediately.
4. Do not place any objects on the product.
5. Install on a flat surface with no vibration or slant, and do not tilt or lay horizontally.
6. Use distilled water with the coolant, regularly check the amount of coolant, and replenish
as needed (must be replenished every year).
7. If a leak is found, turn off the system immediately, and contact the place of purchase
or ZALMAN.
8. If the system will not be used for an extended period of time, then turn the Water
Pump OFF.
9. When moving the system, separate the Reserator from the PC case before moving.
10. Do not let any air bubbles form inside the Water Block and the tubes during operation.
11. Always make sure that the Water Pump is functioning properly.
12. If the power supply cord is damaged, it must be replaced by the manufacturer, its
service agent, or a similarly qualified person in order to avoid a hazard.
Operational Notes
Installation and Operational Notes