ZALMAN VF2000 LED User Manual - page 8
7
5. Installation of Nipple B
Install the short end of Nipple B onto the Clip that was previously Installed
onto the VF2000.
(Note)
The Nipples MUST be tightened by hand. Using tools to tighten the
Nipples may damage the tips of the Nipples .Please take extra precaution
when fastening the Nipples.
6. Spring Insertion on the Fixing Nut
Slowly turn the Spring in counter clockwise motion so that the Spring is
correctly attached to the Fixing Nut.
Note 1)
The ends of the Springs are of different diameters. Install the Spring end
with the smaller diameter on the Fixing Nut as shown in the diagram.
Note 2)
Make sure that the Spring is installed perpendicularly and not leaning to
one side.
4) Place a PVC Washer over each Nipple B on the back side of the motherboard.
5) Slightly screw each of the four Spring-attached Fixing Nuts onto each Nipple, then tighten each Fixing Nut one
rotation at a time until all are completely tightened.
Note 1) Fully tightening one Fixing Nut at a time may result in poor contact between the CPU and the Cooler.
Please tighten each Fixing Nut one rotation at a time until all are completely tightened.
Note 2) Excessive force exerted on the Fixing Nut may cause damage to the cooler and/or system.
Note 3) Make sure that the CPU Cooler’s Base and the CPU are properly in contact with each other.
Note 4) Make sure that the CPU Cooler does not interfere with the motherboard’s capacitors and other
components.
7. CPU Cooler Installation
1) Insert the Rubber Rings B to the Nipples B that are attached to the VF2000.
2) Install the Nipple B-attached CPU Cooler on the motherboard’s Mounting Holes.
※
The MUST be positioned on the center of the Cooler’s Base.
Note 1) Install the cooler so that the ends of the heatpipes are directed towards the case’s exhaust fan.
Note 2) If physical interference results, rotate the cooler 90
。with respect to the CPU(for AM2/AM2+ sockets
rotate 180
。) to avoid interference.
3) Simultaneously hold the CPU Cooler and the motherboard with one hand, then flip the motherboard so that its
backside is facing upwards.
(Note)
Make sure that the VGA Chipset and the VGA Cooler’s base do not get detached while simultaneously flipping
the VGA Cooler and the VGA card.