ZALMAN ZM-RWB1 User Manual - page 4
※
The specifications of any product may change without prior notice to improve performance.
3
5. Installation
1) Install VGA RAM Water Block
Place the Thermal Tapes on top of the VGA RAM, remove the film of the Thermal Tapes, and install the ZM-RWB1
on top of these Thermal Tapes by exerting a downward force as shown in the diagram.
Note 1) If Thermal Grease or other residue remains on the
VGA RAM, then the Thermal Tapes will not stick.
Clean the VGA RAM surface with acetone or alcohol
before attaching.
Note 2) The bonding strength of the Thermal Tapes reaches
90% after 24 hours of curing. Press down once again
after two hours of initial attachment.
Note 3) Thermal Tapes are not reusable because they lose
adhesiveness after their initial attachment.
Purchase new Thermal Tapes if you need to make
reattachments.
2) Attach Clip
Attach the Clip by pushing it up into GWB3’s ATI hole as
shown in the diagram.
3) Connect with GWB3
Install GWB3 with the Clip hooked into the ATI hole as
shown in the diagram.
Note 1) Hooking the RWB1 Clip into the ATI hole positioned
on the upper region of the VGA water block will
create tension. Now hook the other side of the
RWB1 Clip on to the upper part of the RWB1 in
order to effectively install the RWB1.
Note 2) For more information on GWB3 installation, please
visit www.zalman.co.kr to view the installation video.
Thermal
Tape
VGA RAM
ATI Hole
Clip
Clip