ZALMAN ZM-RWB1 User Manual - page 5
※
The specifications of any product may change without prior notice to improve performance.
4
4) Install Tubes
Connect the tubes with the VGA water block and VGA RAM water block’s fittings, and install the Tube Clamps.
Note 1) Hold the VGA water block and VGA RAM water block with one hand to keep them from moving
when installing the tubes.
Note 2) Cutting the tubes to adequate length beforehand will simplify the process of connecting the tubes
with the VGA water block and RWB1.
5) Check Installation
Connect the tubes to the VGA water block and VGA RAM water block’s fittings as shown in the diagram, and
install the Tube Clamps.
Note 1) Check to see if the tubes are connected
as shown in the picture on the right, and
check if the tubes are properly connected
by pulling on them.
Note 2) After confirming connection, press onto the
VGA RAM water block one more time after
two hours, check for leakage, and start the
system.
Inlet
Outlet