ZALMAN ZM-WB3 Gold User Manual - page 5
※
The specifications of any product may change without prior notice to improve performance.
4
6. Installation
※
ZM-WB3 Gold must be installed with a specific grip that is
compatible with a particular CPU socket. Refer to the table
on the right for the correct grip.
1) Intel Pentium 4 - 775
① Installing the Clip Support for Socket 775
Align the clip support for socket 775 and the backplate for socket 775 with the mounting holes on the motherboard
and fasten them together using the Clip Support Fixing Bolts. The Lever Slot on the Clip Support should be properly
oriented on the hinged side of the Socket Lever when installing.
※
The Backplate Support is used for the
convenience of installation.
You can remove it if it is not
deemed necessary.
② Applying Thermal Grease
Clean off particles and residue then spread a
generous amount of thermal grease thoroughly
on top of the CPU.
※
Unlike the flat-milled base of the FHS, the top surface
of the LGA775 CPU may have minute dips and peaks
causing pockets of non-contact between the FHS and
CPU. Please apply a generous amount of Thermal
Grease on top of the CPU.
③ Installing the Grips and Bolts
Interlock the S-type grips with the clip.
Insert the two Bolts into the holes of the Grips.
④ Installing the CPU Water Block
Set the CPU Water Block at the center of the CPU.
Screw the Bolts in slightly, then tighten each Bolt a
few turns at a time while alternating between the two
until the Grips are completely pressed against
the Clip Support.
Socket
775
478
462
754/939/940
Grip
S-Type
L-Type
S-Type
L-Type
Hole
Hole
Inner Hole
Hole
Outer Hole
Clip Support Fixing Bolt
Socket Lever Hinge
Socket Lever
Lever Slot
Clip Support for Socket 775
Motherboard
Backplate for Socket 775
Backplate Support
Lever Slot
CPU (IHS)
Thermal Grease
Bolt
Grip (S-Type)
CPU Water Block
Grip (S-Type)
Clip Support for
Socket 775