ZANKER KBA23012SK User Manual - page 15
Problem
Possible cause
Solution
The compressor operates continual-
ly.
Temperature is set incorrectly.
Refer to "Operation" chapter.
Many food products were put in
at the same time.
Wait some hours and then check the
temperature again.
The room temperature is too
high.
Refer to climate class chart on the rat-
ing plate.
Food products placed in the ap-
pliance were too warm.
Allow food products to cool to room
temperature before storing.
The door is not closed correctly.
Refer to "Closing the door".
Water flows inside the refrigerator.
The water outlet is clogged.
Clean the water outlet.
Food products prevent that water
flows into the water collector.
Make sure that food products do not
touch the rear plate.
Water flows on the floor.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
Attach the melting water outlet to the
evaporative tray.
The temperature in the appliance is
too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly.
Refer to "Closing the door".
The food products' temperature is
too high.
Let the food products temperature de-
crease to room temperature before
storage.
Many food products are stored at
the same time.
Store less food products at the same
time.
The door has been opened often.
Open the door only if necessary.
There is no cold air circulation in
the appliance.
Make sure that there is cold air circula-
tion in the appliance.
If the advice does not lead to the desired
result, call the nearest brand-mark
service.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. At the same time, with the fingers expand up and
down the transparent cover and unhook it in the
direction of the arrows.
1
1
2
2. Replace the lamp with one of the same power and
shape, specifically designed for household
15