ZANKER SF2000 User Manual - Problem
85
ENGLISH
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.
Mod. ..........
Prod. No. ...........
Ser. No. .........
M
od
. ..........
Prod
. N
o.
...........
Se
r. N
o. ......
...
P0042 BD
Problem
Possible cause
• Water is not visible in the machine:
• The machine, which is the result of modern
technology, runs in a very economical way with
low water consumption. Performance is
nevertheless excellent.
• Spinning starts late or the machine
does not spin:
• The electronic balance control device has cut in
because the laundry is not evenly distributed in the
drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and normal
spinning can resume. If, after 5 minutes, the
laundry is still not evenly distributed in the drum,
the machine will not spin. In this case, redistribute
the load manually and select the spin programme.
• The machine makes an unusual noise
• The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in
the drum when spinning, as well as increased
stability of the machine.
• Detergent residue is left after the wash
cycle
• This is most probably due to non soluble
components contained in modern detergents. It is
not a sign of inadequate rinsing. Brush or shake
the garments and, if necessary, wash them again.
• Foam remains after the last rinse
• Modern detergents can produce foam even after
rinsing, but this will not affect the quality of the
wash.
132989980 SF2000.qxd 15/06/2004 11:19 Pagina 85 (Nero/Process Black pellicola)