ZANKER Washer-dryer Installation And User Instructions Manual - page 8
4
Warning! For transport reasons, the suspended unit located in the machine is locked
in position by four distance pieces and screws. Before operating the machine, remove
the blocking screws, insert a screwdriver in the holes to make the distance pieces
fall out (fig. 3). Save the screws and distance pieces for future use.
N.B. If the distance pieces get stuck inside the machine, open the rear cover panel
and remove them.
C
arefully transport the machine to the connection points.
For perfect operation, the machine should be installed level.
Levelling can be carried by adjusting the feet (Fig. 4) on the machine.
Once the machine is level, block the feet by tightening the lock nuts with a spanner.
C
heck that the voltage written on the technical data plate on the inside of the door
filter corresponds to the mains supply voltage.
The counter, pressure relief valve, supply lines and power connection have all been
designed for the maximum load requested.
Insert the plug in the socket, ensuring that it is fitted with an earth (Fig. 5).
If the electrical socket in which the plug of the machine is inserted is unsuitable,
have the socket replaced by qualified personnel.
It is good practice to avoid the use of adapters, extension leads and multiple sockets*.
T
urn on the tap and allow a good quantity of water to flow until it is clear and free
from impurities. This procedure is especially applicable in the case of new water
systems or those that have remained unused for some time.
Connect the water supply hose to the tap, inserting the filter provided, and hand
tighten (Fig. 6). Check that the other end of the hose is tight on the inlet (Fig. 7).
Position the discharge hose at a minimum height of 60 cm, though not more than
90 cm, from the ground (Fig. 8).
N.B. To prevent siphoning, do not hermetically seal the machine's discharge hose.
If the water system does not have a discharge system, use the special 'U' fitting to
hook the hose over the edge of a washbasin and tie it to the tap (Fig. 9).
Rmeember that the hoses must not be squashed when manoeuvring the machine
against the wall.
Installation
** See warnings (page 2)
Water
connection
Electrical
connection
MIN. 60 C
M
MAX.90 C
M
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9
Fig.3