Zanussi DWS 697 Instruction Booklet - page 21

42

Adjusting the worktop

You can move the worktop forward or backward by 25

mm in order to align the machine with other kitchen

units.

Simply unscrew the two rear retaining screws, move

the top to the required position and then retighten the

screws.

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it

under a close fitting sink unit or a pre-existing top,

providing the dimensions of the recess correspond to

those shown in the picture.

Proceed as follows:

-

Remove the machine’s worktop by unscrewing the 

two rear retaining screws, pull from the front and 

slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling

with the adjustable feet. When inserting the machine,

ensure that the water inlet and drain hoses are not

kinked or squashed.

Levelling

Good levelling is essential for correct closure and

sealing of the door.

When the appliance is correctly levelled, the door will

not catch on the levelling spacers, either side of the

cabinet.

If the door does not close correctly, loosen or tighten

the adjustable feet until the machine is perfectly level.

INS18en

IN26

820

570

÷

600

600

IN05