Zanussi ZBF11420SA User Manual

Other manuals for ZBF11420SA: User Manual

Summary of ZBF11420SA

  • Page 1

    En user manual freezer zbf11420sa.

  • Page 2

    Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 care and ...

  • Page 3

    2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squash- ed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not ...

  • Page 4

    Control panel 1 2 3 4 5 1 pilot light 2 temperature regulator 3 quick freeze light 4 quick freeze switch 5 alarm light switching on insert the plug into the wall socket. Turn the temperature regulator clockwise to a medium setting. The pilot light will light up. Important! If the temperature inside ...

  • Page 5

    Daily use freezing fresh food the freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh food activate the fast freeze function at least 24 hours before placing the food to be frozen in the freezer compartment. Place the fresh...

  • Page 6

    Care and cleaning caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning the equipment has to be cleaned regularl...

  • Page 7

    What to do if… warning! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem possible cause solution the appliance does not operate. The pilot light does not flash. Th...

  • Page 8

    Problem possible cause solution the door is not closed correctly. Refer to "closing the door". The temperature regulator is not set correctly. Set a higher temperature. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "installation". 3. If necessary, replace the...

  • Page 9

    1 2 3 4 5 important! The wires in the mains lead are coloured in accordance with the following code: 1 green and yellow: earth 3 brown: live 5 blue: neutral as the colours of the wires in the mains lead of this appli- ance may not correspond with the coloured markings identifying the terminals in yo...

  • Page 10

    10

  • Page 11

    11.

  • Page 12

    Www.Zanussi.Com/shop 2223 52055-a-452011.