Summary of ZDT311
Page 1
Gb user manual 2 dishwasher zdt311.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 use of the appliance _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 setting the water softener _ _ _ _ _ _ _ _ _ _ _ _ _ 6 use of dishwasher salt _ ...
Page 3
• do not change the specifications or modify this prod- uct. Risk of injury and damage to the appliance. • do not use the appliance: – if the mains cable or water hoses are damaged, – if the control panel, worktop or plinth area are dam- aged, that you can get access to the inner side of the applian...
Page 4
Indicator lights the indicator light comes on when the washing pro- gramme is completed. Auxiliary functions: • level of the water softener. • activation/deactivation of the audible signals. • activation/deactivation of the rinse aid dispenser. • an alarm if the appliance has a malfunction. 1) the i...
Page 5
Washing programmes washing programmes programme degree of soil type of load programme description heavy soil crockery, cutlery, pots and pans prewash main wash up to 70°c 2 intermediate rinses final rinse drying 1) any crockery, cutlery, pots and pans prewash main wash up to 45°c or 70°c 1 or 2 inte...
Page 6
Use of the appliance refer to the following instructions for each step of pro- cedure: 1. Make a check if the water softener level is correct for the water hardness in your area. If necessary set the water softener. 2. Fill the salt container with dishwasher salt. 3. Fill the rinse aid dispenser wit...
Page 7
1 2 set switch to position 1 or 2. Electronic adjustment the water softener is set at the factory at level 5. 1. Switch on the appliance. 2. Make sure that the appliance is in setting mode. 3. Press and hold function buttons b and c until the indicator lights for function buttons a, b and c start to...
Page 8
Use of rinse aid caution! Only use branded rinse aid for dishwashers. Do these steps to fill the rinse aid dispenser: 1 2 3 4 5 fill when the rinse aid in- dicator (b) becomes clear. Caution! Do not fill the rinse aid dispenser with other products (e.G. Dishwasher cleaning agent, liquid detergent). ...
Page 9
1 arrange service dishes and large lids around the edge of the lower basket. 2 3 the rows of prongs in the lower basket can be flat to load pots, pans and bowls. 1 2 use the cutlery grid. If the dimensions of the cutlery prevent use of the cutlery grid, remove it. Put long-bladed knives and long or ...
Page 10
1 2 do these steps to move the upper basket to the upper or lower position: 1. Move the front runner stops (a) out. 2. Pull the basket out. 3. Put the basket in the upper or lower position. 4. Replace the front runner stops (a) in their initial po- sition. Caution! If the basket is in the upper posi...
Page 11
Multitab function the multitab function is for combi detergent tablets. These tablets contain agents such as detergent, rinse aid and dishwasher salt. Some types of tablets can contain other agents. Do a check if these tablets are applicable for the local water hardness. Refer to the instructions fr...
Page 12
2. Release function buttons b and c to cancel the wash- ing programme. At this time you can do these steps: 1. Switch off the appliance. 2. Set a new washing programme . Fill the detergent dispenser with detergent before you set a new washing programme. Interrupting a washing programme open the door...
Page 13
3 to remove filters b and c, turn the handle approxi- mately 1/4 anticlockwise. 4 remove the flat filter a from the bottom of the ap- pliance. 5 put the flat filter a in the bottom of the appliance. Install the flat filter cor- rectly under the two guides d. 6 put the filter system in po- sition. To...
Page 14
Fault code and malfunction possible cause and solution • continuous flash of the light of the run- ning programme • intermittent audible signal • 1 flash of the end indicator light the dishwasher does not fill with water • the water tap is blocked or furred with limescale. Clean the water tap. • the...
Page 15
The cleaning results are not satisfactory the dishes are not clean • the selected washing programme is not applicable for the type of load and soil. • the baskets are loaded incorrectly so that water cannot reach all surfaces. • spray arms do not turn freely because of incorrect arrangement of the l...
Page 16
Warning! To discard the appliance, follow the procedure: • pull the mains plug out of the socket. • cut off the mains cable and mains plug and discard them. • discard the door catch. This prevents the children to close themselves inside the appliance and endanger their lives. Installation warning! M...
Page 17
• do not put the water inlet hose or the safety valve in water. • if the water inlet hose or the safety valve is damaged, immediately disconnect the mains plug from the mains socket. • only let the service force centre replace the water inlet hose with safety valve. Drain hose 1 connect the water dr...
Page 18
18.
Page 19
19.
Page 20
Www.Zanussi.Com 156 95 031 0-00 -022 00 9.