Gas hob zgf 786 instruction booklet please read this instruction booklet before using the appliance ru.
2 important safety information guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information ) ) ) ) ) about installation, cleaning and ma...
3 hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : z there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before putting a pan on the pan sup...
4 fig. 2 fo 2238 caution! When removing the cast iron pan supports, lift them up as shown in fig. 2. Never turn the pan supports on the hinges as shown in fig. 3, since this could damage them. Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. ...
5 gas burners rating ultra rapid burner (triple crown) 4,0 kw rapid burner (big) 2,8 kw semirapid burner (medium) 2,0 kw auxiliary burner (small) 1,0 kw class 3 appliance category ii2h3b/p setting natural gas g20 20 mbar gas connection g 1/2" electric supply 230 v ~ 50 hz hob recess dimensions lengt...
6 z z z z z the following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. Z z z z z the appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to ...
7 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...
8 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedure backwa...
9 a = auxiliary burner sr = semi rapid burner r = rapid burner ur = ultra rapid burner these hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in fig. 9. Fig. 9 building in a sr sr 680 ur r 510
10 installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 10. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the ...
11 possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in fig. 13. The panel fitted under the hob shou...
