Zanussi ZGG66424 User Manual

Other manuals for ZGG66424: User Manual, User Manual

Summary of ZGG66424

  • Page 1

    En user manual gas hob zgg66424 eg.

  • Page 2: Contents

    Contents safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 product description _ _ _ _ _ _ _ _ _ _ _ _ _ 7 operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 8 care and cleaning _ _ _ _ _ _ _ _ _ _ _...

  • Page 3

    Hot cookware, when you connect the appli- ance to the near sockets • make sure the appliance is installed correct- ly. Loose and incorrect electricity mains ca- ble or plug (if applicable) can make the termi- nal become too hot. • make sure that a shock protection is instal- led. • use the strain re...

  • Page 4: Installation

    Jects up when you have to move them on the cooking surface. • provide good ventilation in the room where the appliance is installed. • make sure that the ventilation openings are not blocked. • use only stable cookware with the correct shape and diameter larger than the dimen- sions of the burners. ...

  • Page 5

    – it is not subject to traction or torsion; – it does not get in touch with cutting edges or corners; – it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: – it does not show cracks, cuts, marks of burn- ings on the t...

  • Page 6

    Ground connection is in conformity with the standard and regulations force. • the power cable must be placed in such a way that it does not touch any hot part. • connect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening ...

  • Page 7: Product Description

    Product description cooking surface layout 3 4 5 1 2 1 cooktop 2 semi-rapid burner 3 triple crown burner 4 auxiliary burner 5 control knobs control knobs symbol description no gas supply / off posi- tion symbol description ignition position / maxi- mum gas supply minimum gas supply operation warning...

  • Page 8: Helpful Hints And Tips

    3 4 2 1 1 2 3 4 1 burner cap 2 burner crown 3 ignition candle 4 thermocouple warning! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 min...

  • Page 9: Care And Cleaning

    Warning! Pots must not enter the control zone. Flame will heat up the control zone. Do not put the same pan on two burners. Warning! Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to achieve maximum stability and ...

  • Page 10: What to Do If…

    Removing the dirt: 1. – remove immediately: melting plastic, plastic foil, and food containing sugar. – stop the appliance and let it cool down before you clean: limescale rings, water rings, fat stains, shiny metallic dis- colorations. Use a special cleaner appli- cable for surface of hob. 2. Clean...

  • Page 11: Technical Data

    If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local service force centre. If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visi...

  • Page 12: By-Pass Diameters

    Category: ii2h3+ gas connection: g 1/2 gas supply: g20 (2h) 20 mbar appliance class: 3 by-pass diameters burner Ø by-pass in 1/100 mm auxiliary 28 semi-rapid 32 triple crown 56 gas burners burner normal power re- duced power normal power natural gas g20 (2h) 20 mbar lpg (butane/propane) g30/g31 (3+)...

  • Page 13

    13 www.Zanussi.Com.

  • Page 14

    14 www.Zanussi.Com.

  • Page 15

    15 www.Zanussi.Com.

  • Page 16

    Www.Zanussi.Com/shop 397 276201-b-212 012.