Summary of ZGG66424
Page 1
En user manual hob zgg66424 ie gb.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 care and...
Page 3
Pliance or hot cookware. Do not let the electricity bonds tangle. Installation • you must read these instructions. The manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these re- quirements. • to prevent the risks of structural damage ...
Page 4
– cut off the mains cable where it connects with the appliance and discard it. – flat the external gas pipes if there are fitted. – speak to your local authorised facilities for disposal of your appliance. Installation warning! The following instructions about installation, connection and maintenanc...
Page 5
Not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. Important! It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the hob connecting pipe. Important! Failure to ensure the correct ...
Page 6
Electrical requirements permanent electrical installation must comply with the lat- est i.E.E. Regulations and local electricity board regula- tions. For your own safety the installation must be done by a qualified electrician (e.G. Your local electricity board, or a contractor who is on the roll of...
Page 7
B a a) supplied seal b) supplied brackets possibilities for insertion kitchen unit with door the panel installed below the hob must be easy to remove and let an easy access in case a technical assistance inter- vention is necessary. Min 20 mm (max 150 mm) 30 mm 60 mm b a a) removable panel b) space ...
Page 8
Control knobs symbol description no gas supply / off posi- tion symbol description ignition position / maxi- mum gas supply minimum gas supply operation ignition of the burner warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misu...
Page 9
If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installation or a pow- er cut. It is normal. Turning the burner off to put the flam...
Page 10
Warning! Do not use abrasive cleaners, steel wool pads or acids. They can cause damage to the appliance. Scratches or dark stains on the surface have no ef- fect on how the appliance operates. • you can remove the pan supports to easily clean the hob. • to clean the enamelled parts, cap and crown, w...
Page 11
Problem possible cause remedy the flame is blow out immediately af- ter ignition • thermocouple is not heated suffi- cient • after lightning the flame, keep the knob pushed for approximately 5 seconds. The gas ring burns unevenly • burner crown is blocked with food residues • make sure that the inje...
Page 12
Heat input triple crown burner: 4.0 kw semi-rapid burner: 2.0 kw auxiliary burner: 1.0 kw total power: g20 (2h) 20 mbar = 9 kw g30 (3+) 28-30 mbar = 654 g/h g31 (3+) 37 mbar = 643 g/h electric supply: 230 v ~ 50 hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse gas...
Page 13
13 www.Zanussi.Com.
Page 14
14 www.Zanussi.Com.
Page 15
15 www.Zanussi.Com.
Page 16
Www.Zanussi.Com/shop 3972 25901-a-492011.