Instruction booklet ÐÓÊÎÎÄÑÒÎ ÏÎ ÝÊÑÏËÓÀÒÀÖÈÈ ru gas hob ÃÀÇÎÀß ÀÐÎ×ÍÀß ÏÎÅÐÕÍÎÑÒÜ zgl 646 zxl 636.
2 about installation, cleaning and manteinance • it is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. • disconnect the appliance from the electrical supply, before carrying out any cle...
3 once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. Hob burners control knobs the hob burners control knobs are situated on the hob right hand side. The symbols on the knobs mean that: there is no gas supply there is maximum gas su...
4 burner minimum maximum diameter diameter big (rapid) 160 mm. 260 mm. Medium (semirapid) 120 mm. 220 mm. Small (auxiliary) 80 mm. 160 mm. Using the hob correctly to ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the bur...
5 cleaning and maintenance disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. General cleaning wash the enamelled components with warm soapy water. Never use abrasive cleaners. Frequently wash the "caps" and the "crowns" with hot soapy water, c...
6 gas burners rating rapid burner 3,0 kw (g20) - 2,8 kw (g30/g31) semirapid burner 2,0 kw auxiliary burner 1,0 kw appliance class 3 category ii2h3b/p setting natural gas g 20 20 mbar gas connection g 1/2" • the following instructions about installation and maintenance must be carried out by qualifie...
7 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...
8 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedu- re back...
9 these hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in the relevant diagram. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob...
1 0 a) removable panel b) space possibly useful for connections fig. 11 fig. 12 fig. 14 fig. 15 fo 1013 fo 0947 fo 0198 kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is op...
1 1 service and original spare parts this machine, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we recco...
