1. DL manuals
  2. Zanussi
  3. Washer/Dryer
  4. ZKH 2145
  5. User Manual

Zanussi ZKH 2145 User Manual - What to Do If…

Other manuals for ZKH 2145: User Manual, User Manual

Summary of ZKH 2145

  • Page 1

    En user manual washer dryer zkh 2145.

  • Page 2: Contents

    Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 automatic drying programmes _ _ _ _ _ _ _ 11 timed drying programmes _ _ _ _ _ _ _ _ _ 11 ...

  • Page 3: Safety

    • do not change the specification of this appliance. • obey the maximum load volume of 7 kg (refer to the “programme chart” chapter). • if the supply cord is damaged, it must be replaced by the manu- facturer, its service agent or similarly qualified persons in order to avoid a hazard. • the operati...

  • Page 4

    Water connection • make sure not to cause damage to the water hoses. • the appliance is to be connected to the wa- ter mains using the new supplied hose-sets. Old hose sets must not be reused. • before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until...

  • Page 5: Product Description

    Product description 1 detergent dispenser drawer 2 control panel 3 door opening handle 4 rating plate 5 drain pump 6 adjustable feet 1 2 3 4 5 6 child safety make sure that children or pets do not climb in- to the drum. To prevent children and pets be- coming trapped inside the drum this machine in-...

  • Page 6: Control Panel

    Follow the instructions supplied with the kit. Rubber feet kit (4055126249) available from your authorized dealer. The rubber feet are particularly recommended on floating, slippery and wooden floors. Mount the rubber feet to prevent vibration, noises and displacement of the appliance dur- ing opera...

  • Page 7

    7 start/pause button 8 delay start button 9 door pilot light 10 display 1-8 programme selector dial, spin speed button, drying level and time, and available options programme selector dial it allows you to switch the appliance on/off and/ or to select a programme. Spin by pressing this button you ca...

  • Page 8

    10 display 10.1 10.2 the display shows the following information: 10.1 child safety lock this device permits you to leave the appliance unattended during it's functioning. 10.2 • duration of the selected programme after selecting a programme, the duration is displayed in hours and minutes (for examp...

  • Page 9

    Washing programmes programme - maximum and minimum temperature - cycle description - maximum spin speed - maxi- mum fabrics load - type of laundry options detergent com- partment katoen - coton 90° - 60° main wash - rinses maximum spin speed at 1400 rpm max. Load 7 kg - reduced load 3,5 kg 1) white ...

  • Page 10

    Programme - maximum and minimum temperature - cycle description - maximum spin speed - maxi- mum fabrics load - type of laundry options detergent com- partment fijne was - délicats 40° - 30° main wash - rinses maximum spin speed at 700 rpm max. Load kg 7 - reduced load kg 1,5 1) delicate fabrics: ac...

  • Page 11: Automatic Drying Programmes

    Programme - maximum and minimum temperature - cycle description - maximum spin speed - maxi- mum fabrics load - type of laundry options detergent com- partment draining of water max. Load 7 kg for emptying out the water of the last rinse in programmes which stop with water in the tub. Drain and long...

  • Page 12: Consumption Values

    Degree of drying type of fabric drying load spin speed suggested drying time in minutes iron dry suitable for ironing cotton and linen (sheets, tablecloths, shirts, etc.) 5 kg 1400 155-165 3,5 kg 1400 75-85 1,5 kg 1400 40-50 1) in compliance with ec directive en 50229 the cotton reference programme ...

  • Page 13

    Removing stains stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a spe- cial detergent then rub in the soap and water. Oil based paint: m...

  • Page 14: Drying Hints

    Drying hints preparing the drying cycle as a dryer, the appliance works on the conden- sation principle. Therefore, the water tap must be open and the drain hose must drain water into a sink or into the drain pipe, even during the drying cycle. Attention! Before starting the drying programme, reduce...

  • Page 15: Personalisation

    Laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of deter- gent into the main wash compartment and start the machine. Personalisation acoustic signals the machine is provided with an acoustic de- vice, which sounds in the following cases: • at the...

  • Page 16

    Select the required programme by means of the programme selector dial (1) turn the programme selector dial to the re- quired programme. The green pilot light of button 7 starts to flash. The selector dial can be turned either clockwise or anticlockwise. Turn the selector dial to position to reset th...

  • Page 17

    Important! • the selected delay can be changed only after selecting the washing programme again. • the door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to pause by pressing button 7 and wait a few minutes be- fore opening the door. A...

  • Page 18: Use - Drying

    Use - drying drying only caution! The recommended load size is 3,5 kg for cot- tons and linen and 2 kg for synthetic items. By pressing drying time button it is also possible to dry up to 5 kg of cotton items (see the «drying programme » table). Caution! The water tap must be open and the drain hose...

  • Page 19

    If possible, do not select a spin speed lower than that proposed by the ap- pliance to avoid too long a drying time therefore saving energy. In any case the reduction of the spin speed is only possible after selecting drying. For cottons and synthetic the lowest value you can select is 900 r.P.M. 5....

  • Page 20: Care And Cleaning

    Care and cleaning warning! You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling the water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately fr...

  • Page 21

    Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull forward the drainage duct to let the water flow out. When the container is full of water, put the drainage duct back again and empty the con- tainer. Do steps 3 a...

  • Page 22

    Cleaning the water inlet filters important! If the appliance doesn't fill, takes long to fill with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "what to do if..." for more details), check if the water inlet filters are blocked . To clea...

  • Page 23: What to Do If…

    1. Put 2 litres of water in the main wash com- partment of the detergent dispenser. 2. Start the programme to drain the water. What to do if… certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local...

  • Page 24

    Problem possible cause/solution the machine does not empty and/or does not spin: the drain hose is squashed or kinked. • check the drain hose connection. The drain filter is clogged. • clean the drain filter. An option or a programme that ends with the water still in the tub or a that eliminates all...

  • Page 25

    Problem possible cause/solution spinning starts late or the machine does not spin: the electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by re- verse rotation of the drum. This may happen several times before the ...

  • Page 26: Technical Data

    If you are unable to identify or solve the prob- lem, contact our service centre. Before tele- phoning, make a note of the model, serial num- ber and purchase date of your machine: the service centre will require this information. Mod. ... ... ... Pr od. No. ... ... ... Ser . No. ... ... ... Mo d . ...

  • Page 27

    Unscrew the three bolts. Slide out the relevant plastic spacers. Open the porthole, remove the polystyr- ene block fitted on the door seal and pull out all items from the drum. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing ...

  • Page 28: Environment Concerns

    Connect the other end of the inlet hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type ...

  • Page 29

    • the machine works more economically if it is fully loaded. • with adequate pre-treatment, stains and limi- ted soiling can be removed; the laundry can then be washed at a lower temperature. • measure out detergent according to the wa- ter hardness, the degree of soiling and the quantity of laundry...

  • Page 30

    30 www.Zanussi.Com.

  • Page 31

    31 www.Zanussi.Com.

  • Page 32

    Www.Zanussi.Com/shop 1329 64551-a-1420 1 3.