Zanussi ZMD 905 W Operating And Installation Manual - Cleaning The Oven
24
Cleaning the oven
Before cleaning always allow the
cooling fan to cool the oven down
before switching off at the electricity
supply
Cleaning materials
Before using any cleaning materials on your oven,
check that they are suitable and that their use is
recommended by the manufacturer.
Cleaners that contain bleach should NOT be used
as they may dull the surface finishes. Harsh
abrasives should also be avoided.
Glass Panel
This should be cleaned with a soft cloth soaked in
warm soapy water. Do not use abrasive scourers
or steel wool.
Oven Shelves and Shelf Support
To clean the oven shelves and shelf support, soak
in warm soapy water and remove stubborn marks
with a well wetted soap impregnated pad. Rinse
well and dry with a soft cloth.
The shelf supports can be removed for easy
cleaning (see Fig. 6). Please ensure the retaining
nuts aresecure when refitting the shelf supports.
Fig. 8
Electric bulb: 15W, 220-240 V, 50 Hz, 300
°
C,
E14.
These bulbs are available from your local Zanussi
Service Centre whose address can be found in the
Zanussi Customer Care Booklet.
Fig. 6
Oven Cavity
The enamelled oven cavity is best cleaned whilst
the oven is still warm. It is advisable to wipe the
oven over with a soft cloth soaked in warm soapy
water after each use. However, from time to time it
will be necessary to do a more thorough cleaning,
using a proprietary oven cleaner.
Grease Filter
When cooking meat the grease filter must be fitted
over upper oven fan by clipping it over the vents
in the back panel, this will prevent a built-up of fat
on the fan impellor. Do not use abrasive materials
to clean the seal. The grease filter is dishwasher
proof.
When cooking is completed and the oven has
cooled down, remove the filter as instructed below
and wash carefully.
- Push the protruding tongue on the filter, upward
(see Fig. 7).
Fig. 7
Replacing Components
Prior to undertaking any maintenance work or
replacing the oven light, be sure to disconnect
appliance from the electricity supply.
Replacing The Oven Light
Push in and turn the glass lid anticlockwise (Fig. 8).
Remove the faulty bulb and replace with one
which is heat resistant to 300
°
C.
FO 0018
FO 0145
FO 0030