Zavig D7320 User Manual - Event
SD Card
Make
sure to insert the SD Card first then click “on”. Create a folder name for event server in SD Card.
Optional
selection for overwrite the previous file or not, if not, you may set a warning when the capacity below
the
following percentage:5%, 10%, 25% and 50%.
Event
List
Event List
General
Name
the event file and make it on or off.
Trigger
You
may activate the following trigger types as you wish depends on various conditions:
Motion
Detection: Click it on for using Motion Detection function as a sensor. You must configure
motion
detection function before taking this as the trigger. Set minimum time interval between 2 triggers,
and
choose the desired detection area. The detection type individually stands for the following meanings :
Start:
The trigger would be activated when the target object starts to move.
Stop:
The trigger would be activated when the target object stops to move.
Tampering Detection:
This setting is set for the trigger will be started for the duration of tampering lasts you configure. The
Duration range is from 5 seconds to 900 seconds.
Digital Input:
This can be set to control the external alarm input of I/O port on the rear of the device to start the trigger.
Periodical:
This
can be set the certain period(by minute) to start the trigge.
Action
There are three choices for action taking which is optional for user to select all of them or part of them:
Send Image、Send Notification and Activate Digital Output.
Send
Image: You may set up where the image sent to, options like event server and SD card. You must
configure
it first, please refer to Event Server.
Send
Notification: Firstly go to HTTP server configure the HTTP server URL, port, User ID, Password, and Proxy
server settings.
Note:
The Setting of URL should be the same as CGI.
Activate Digital Output:
Choose this option to enable the external digital output device when a trigger is
triggered.
19