Zavio D3100 User Manaul - Event List
21
SD Card
Make sure to insert the SD Card first then click “on”. Create a folder name for event server in SD Card.
Optional selection for overwrite the previous file or not, if not, you may set a warning when the capacity below
the following percentage:5%, 10%, 25% and 50%.
Event List
Event List
General
Name the event file and make it on or off.
Trigger
You may activate the following trigger types as you wish depends on various conditions:
Motion Detection: Click it on for using Motion Detectionfunction as a sensor. You must configure
motion detection function before taking this as the trigger. Set minimum time interval between 2
triggers, and choose the desired detection area. The detection type individually stands for the
following meanings:
Start: The trigger would be activated when the target object starts to move.
Stop: The trigger would be activated when the target object stops to move.
Start-Stop: The trigger would be activated during the target object starts to move till it stops.
Audio Detection: Click it on for using Audio Detectionfunction as a sensor. You must configure
audio detection function before taking this as the trigger. Set minimum time interval between 2
triggers. The detection type stands for the following meanings individually:
Start: The trigger would be activated when the sound being made.
Stop: The trigger would be activated when the
sound being cut off.
Start-Stop: The trigger would be activated during the
sound being made and cut off.
Tampering Detection: This setting is set for the trigger will be started for the duration of tampering lasts
you configure. The duration range is from 5 seconds to 900 seconds
Digital Input: This can be set to control the external alarm input of I/O port on the rear of the device to
start the trigger.
Periodical: This can be set the certain period(by minute) to start the trigger.
On boot: The event is triggered when the IP Camera has been started over .
Capacity Warning: This is triggered when SD Card capacity is be below the value you set.