Zavio F7110 Quick Installation Manual - page 2
2
WPS: Push WPS button to configure wireless connection automatically. This function is only available in F7115.
Reset: When the device is powered, press the Reset Button to reboot the device, or hold the Reset Button for 10
seconds to set the settings back to factory default.
I/O Terminal Block Pin Definition
PIN Definition
Description
Max.
V/A
1
Ground
-
2
+ 12V DC
12V
DC
1.2W
3
RS-485 -
-
4
RS-485 +
-
5
Digital Output 1
Uses an NPN transistor with the emitter connected to the GND
pin. If used with an external relay, a diode must be connected in
parallel with the load for protection against voltage transients.
100 mA
24V
6
Digital Output 2
Uses an NPN transistor with the emitter connected to the GND
pin. If used with an external relay, a diode must be connected in
parallel with the load for protection against voltage transients.
100mA
24V
7
Alarm Input 1
Connected to GND to activate, or leave floating (or unconnected)
to deactivate.
30V DC
8
Alarm Input 2
Connected to GND to activate, or
leave floating (or unconnected) to deactivate.
30V DC
SD Card LED Indicator
Power LED Indicator
WLAN LED Indicator
(F7115)
8 7 6 5 4 3 2 1