Zaxcom IFB200 User Manual - page 11
Zaxcom IFB200
Main Menu
10
•
6: POWER=LOW2 – This setting will put the TRX transmitter into and out of a low power setting.
You can come in and out of LOW 2 mode as needed. When you are in LOW 2 mode “LOW 2” will be
displayed on the TRX’s home screen. Note LOW 2 will not disable recording but it will be muted.
Once you have reduced the TRX power to Low 2 you can power down your TRX900CL. Once you
power up the IFB200 all TRX’s being controlled will automatically come up to full power since after a
power cycle the IFB200 will always boot up to the 0 Power setting.
Please note if the TRX transmitter is not in range of the ZaxNet signal, the power setting command will have
to be repeated once the transmitter comes back into range.
Playback Control
Recorded files can be played back from this page.
The top line displays the current mode of the recorder: REC, PLAY or STOP followed by the time code.
The bottom line contains the current segment number and the audio level.
Playing back from the transport page:
•
Pressing the INC key while stopped will play the segment that is displayed.
•
Pressing the INC key while in play mode will fast forward.
•
Pressing the DEC key while playing back will stop the playback.
•
Holding the DEC key while playing back will take you to the start of that segment.
•
Pressing the DEC key while stopped will rewind.
Timecode Routing
The time code routing menu sets the function of the BNC time code connector.
•
OUTPUT - TheIFB200 will output time code on the BNC connector.
•
INPUT - The IFB200 will receive time code on the BNC connector.
Time Code Frame Rate Select
The time code frame-rate that will be recorded and transmitted over ZaxNet is set from this menu.
The IFB200 will lock to and transmit all standard time code frame rates.
•
23.98, 24, 25, 29.97DF, 29.97DF, 30 DF, 30 NDF
IFB Audio Mix
TIMECODE 23.98
GEN 01:02:34:01
IFB TX MIX:
LEFT AND RIGHT
TC CONNECTOR:
OUTPUT
PLAY 01:02:34:01
001