ZBoost YX645 User Manual - page 2
zBOOST® YX645 USER GUIDE
zBOOST® YX645 USER GUIDE
i
About zBoost® from Wi-Ex®
Wi-Ex
® is the leader in cell phone signal boosters. zBoost® enhances the performance of your cell
phone, PDA and wireless data card.
Compatibility –
Dual Band zBoosts are compatible with 800MHz and 1900MHz regardless of
technology- including CDMA and GSM.
Patented technologies protect the carrier network.
1-year manufacturer warranty – register your product at www.Wi-Ex.com.
zBoost® products have more awards, more sales and more locations than all other signal boosters
…COMBINED.
FCC ID: SO4YX545-PCS-CEL
Warning:
Changes or modifi cations to this device not expressly approved by Wi-Ex® could void the user’s
authority to operate the equipment.
Note:
Th
is equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. Th
ese limits are designed to provide reasonable protection against
harmful interference in a residential installation. Th
is equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If the equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit diff erent from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Th
is equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Th
is transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
In accordance with FCC requirements of human exposure to radiofrequency fi elds, the radiating element
(antenna) shall be installed such that a minimum separation distance of 20cm (8in) is maintained from all
persons.
FCC Information
Industry Canada Regulations
IC ID: 5544A-YX545PCSCEL
Th
is Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Th
e term “IC:” before the radio certifi cation number only signifi es that Industry Canada technical
specifi cations were met.
RF Exposure:Th
e manufacturer’s rated output power of this equipment is for single carrier operation.
For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB,
especially where the output is re-radiated and can cause interference to adjacent band users. Th
is power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device.