ZComax ZLF-372 Quick Installation Manual - page 5
6. Use a center punch where it is practical to
dimple the pole you are going to drill.
7. Try drilling a pilot hole with a small
diameter bit. If you are successful in drilling
the hole without the bit slipping, and are
satisfied with the results, step up to larger
bits until you have a sufficiently large hole
for your purpose.
8. Insert the M5xL40 screw into the drilled
hole and use the nut to tighten to secure
the bracket to pole.
If there
is no significant movement, you are
probably tight enough. If the M5xL40 screw
is not long enough to secure the bracket,
use other longer screw instead.
Pole Mount _Vertical
Pole Mount _Horizontal
MOUNTING ON A FLAT SURFACE
1. Attach the bracket ① on the ZLF-372 using
the four M5xL10 screws.
2. Mark two screw holes with bracket② on
the place you have selected where the
power is available nearby on the vehicle.
3. Use a drill to create two holes on the two
markings you created in the previous step.
4. Attach bracket② on the bracket① using
three M5xL10 screws and nuts.
5. Attach the cable cover to the junction box
using the screws from the removed cover
plate.
6. Insert two M4xL20 screws into the
installation holes and tighten up.
Flat Surface Mount _Bottom