Zeck Audio STAC CL8CT Owner's Manual - page 6
2. Operation
On powering up the unit the LED´s will chase and then the unit will start to
chase with the standby LED flashing, no outputs will be on.
Power:
To output the pattern to the lights press the
Power
button. There are three set-
tings that you can select by repeated pressing of the
Power
button. The
sequence is shown below.
Full
Outputs at full power
Preset
Outputs at preset level (50% on power up, press
Power
and
UP / Down
to change)
Standby
Outputs off
Pattern Speed:
To change the chase speed press either
Up
to increase the chase speeed or
Down
to de-crease the chase speed. During these operations the display will
show
CS
( chase speed )
Animation:
The chase can be stopped or triggered by two different methods. These are sel-
ected by use of the
Animation
button. The sequence is shown below.
Chase
Chase from internal speed.
Manual
Stop chase, trigger manual by pressing
UP / Down
Sound
Chase from bass beat of music
Flash:
The four
Flash
buttons will momentary turn the assiciated output on.
Latch:
Press
Shift & Flash
buttons to hold an output on, until the associated flash but-
ton is
pressed again.
Flood:
All of the outputs can be turned on by pressing
Shift & Power
together. The
display shows
FL
( Flood ).
To release this mode, press
Power
button.