Zeck Audio STAC Vision 1.5 Owner's Manual - page 9
Vision 1.5 owner`s manual
owner`s manual Stac Vision 1.5 © Zeck Audio
9
®
Fuse
Slave
Remote Control
Footswitch
Power
Slave
Remote Control
Footswitch
8.
The fog generator is equipped with an automatic fluid-level control. If the fluid level falls below
its minimum allowed value, the sypply voltage for the fog liquid pump is automatically inter-
rupted, wich is indicated by the red indikator lamp on the unit´s back panel.
For refilling of the tank with original
STAC
®
fog liquid
, pull the plug from the level sensor and
remove the hose from the tank by applying soft pressure to the orange-colored ring at the cap´s
hose conduit. Screw off the tank cap and remove the induction pipe including the level sensor.
The intake side off the induction pipe carries a filter which shuold be checked for dirt. After refil-
ling the tank, reassemble all parts in reverse order. The unit is now ready for operation again.
9.
Do not open unit or connectors unless you are an authorized
STAC
®
service person. The
STAC
®
company is not responsible for any damage resulting from disregarding this warning.
10.
This unit must be earthed through the protective-earth contact on the three-pong mains
connector.
11.
Replacement fuse must have exact specifications as stated on the unit identification label.
Have a lot of fun and success with your
STAC
®
Vision 1.5
See for technical specifications on page 13