Zee Iveda Z-3501 Installation Manual And User's Manual - page 4
of
14
4
Install the Hardware and Connect All Cables
Wall mounting
1. Use the supplied screws to fix the base plate to a flat surface.
2. Loosen the screws on the bracket to aim the viewing area.
3. Tighten the screws at the two joint of the bracket.
Note on installation location
If you plan to install the IP camera outdoors, we recommend you set up the camera in an area where it
will be blocked from direct sunlight and rain.
Cable connection:
With Power over Ethernet
Using standard RJ-45 network cable, connect the IP camera to a PoE-enabled Hub/Switch /
Router.
Without Power over Ethernet
Connect the 12V power adaptor to the IP Camera.
Using a standard RJ45 network cable, connect the IP camera to a normal Hub / Switch / Router.