Zehnder Rittling FV-04 Installation, operation and maintenance manual - page 9
7
Installation
Installation
Preparation
■
■
Verify that electrical power is disconnected prior to installation and
service.
■
■
Ensure that field plumbing and electrical meets applicable national
and local codes and requirements.
■
■
The Rittling Fanvector cabinet has keyhole slots included in the
back panel for use in mounting. Proper wall supports and screws to
support the Rittling Fanvector weight should be used when mounting.
The table below shows model weights for each unit size.
Model
Weight (lbs.)
FV-04
22
FV-06
44
FV-08
66
■
■
Access to the keyhole slots may require removal of the end panels
and the front cabinet panel. Check if keyhole slots are accessible
through access doors or end panels, and that access is not
obstructed by field barriers.
The end caps are attached by a tongue and groove joint and are
removed by simply pulling them away from the ends of the unit.
The front panel is disassembled by removing the screws in the
front panel and lifting the panel vertically.
■
■
Prior to fastening the Rittling Fanvector in place, verify that all wiring
and plumbing is accessible to complete the installation.
■
■
Securely fasten unit into place.