Zektor HDS4 Owner's Manual - page 13
13
Restoring the HDS4 to Factory Defaults
Restoring the HDS4 to the factory defaults
There are many ways to program the HDS4’s remote capabilities. Most learning modes require the
HDS4 to be in standby mode before learning can begin. If the remote used to control the HDS4 were
to be lost, and the HDS4 were programmed to power on during initial power up (as described in
"Setting Power On Defaults" on page 12), there would be no way to reprogram the HDS4 to accept
new remote control codes. Therefore a means of resetting the HDS4 to its factory on defaults has
been included.
Resetting the HDS4 to factory on default is done by removing power to the HDS4. The AC wall
adapter must be unplugged, so that the HDS4 is completely without power. The SETUP key is then
pressed and held while power is restored to the HDS4, after about three seconds the power indica-
tor will flash three times indicating the HDS4 has been reset to power on defaults.
S
TEP
1
1 Remove all power from the HDS4, this can be done by unplugging
the AC wall adapter from the back of the HDS4, or unplugging the
AC adapter from the wall, or by using a switched power strip.
Nothing should be lit on the HDS4.
S
TEP
2
2 Using a pen or pencil, press AND HOLD the SETUP button on the
back panel of the HDS4. While continuing to HOLD the SETUP
key, reapply power to the HDS4. When power is applied, the power
indicator light and the IR indicator light will both light up.
S
TEP
3
3 Continue to HOLD the SETUP key and after about three seconds
the power indicator will blink RED three times indicating the HDS4
has been reset to its factory defaults.
The HDS4 factory defaults, are:
• Control codes used are the Jerrold Cable Box codes.
• Default power up mode is standby.
• Default selected input when powered on is input 1.
• Default brightness mode is Auto-dimming.
1
2
3
4
1
2
3
4
1
2
3
4