Zektor HDVI5 User Manual - page 19
3
HDVI5 Component Video Switch
35
HDVI5 Component Video Switch
Step 1: Reset All Parameters to Factory Defaults
1 2 3 4 5 SEL A1 A2
Start by pressing and
holding the Power
button...
1
2
...while continuing to hold the Power
button, press and hold both the ‘2’
and the ‘3’ buttons.
After about seconds, the display will flash
indicating all parameters have been restored
to their factory programmed values.
3
Resetting to Factory Defaults
If, for whatever reason, you’d like to reset your HDVI5 back to its fac-
tor y default condition, this is easily done...
Step 1: Reset All Parameters to Factory Defaults
First press and hold the Power button
While continuing to hold the Power Button, press and hold
both the ‘2’ and ‘3’ buttons.
After holding all buttons for about seconds, the display
will flash indicating all parameters have been restored to
their factor y programmed values.
Note: Reseting the HDVI5 to its default value, resets ever y-
thing to the same state it was when it lef t the fac tor y!
This includes any learned IR codes, all timing informa-
tion, cable length tuning, etc.
Please be aware of this before issuing this command!
1.
2.
3.