Zelmer 17Z015 User Manual - page 29
29
GW17-034_v01
The rising of the water level in the kettle is
delayed in relation to the speed of pouring. It
is caused by the filter slowing down the speed
of the flow.
This can be prevented by pouring the last
portions of water extremely carefully before
reaching the maximum level on the indicator.
If an empty kettle is switched on, it will be
switched off by a thermal device automatically.
To turn the kettle on again after it has cooled
down (approx. 15 minutes), take it off the base,
replace it and turn the kettle on by pressing
the switch. To accelerate the cooling of the
kettle, pour cold water into the kettle.
When the water has reached the boiling point, the kettle switches off
automatically, the switch returns to its starting position – the light comes off.
If further use of the kettle is anticipated, it is not necessary to remove the
plug of the connecting cord from the power socket.
Cleaning and maintenance
Always clean a cold kettle!
Remove the plug of the connecting cord from the power socket.
–
Take out the filter.
–
Clean the outside surfaces with a soft cloth moistened with washing-up
–
liquid.
To remove the build-up of hard water film from the outside and inside
–
walls of the kettle, wipe them with a cloth moistened with vineger.
Rinse the kettle with fresh water.
–
Filter replacement – descaling
If scale builds up on the bottom of the kettle, it needs to be removed. Use
6% or 10% vinegar for this purpose.
Open the lid.
–
Take out the filter from socket
–
“A”
and from the runners by moving it in
the direction shown by
“2”
.
Wash it under running water.
–
Pour 0.5 l of vinegar into the kettle and turn on the kettle.
–
Boil the vinegar and leave it in the kettle for about 30 minutes.
–
Pour the vinegar out and rinse the
–
kettle with fresh water.
Fill up the kettle with fresh water,
–
boil the water and pour it out after
is has boiled.
Repeat the procedure if there still is
–
scale on the bottom.
When the procedure is finished,
–
replace the fiter in the kettle
following the procedure of taking it
out in reverse order.
Negligence in descaling the kettle
may result in its damage.
Ecology – Environment protection
Each user can protect the natural environment. It is neither
difficult nor expensive.
In order to do it: put the cardboard packing into recycling
paper container; put the polyethylene (PE) bags into container
for plastic.
When worn out, dispose the appliance to particular disposal
centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
removing
the filter
replacing
the filter
The manufacturer/importer does not accept any liability for any damages resulting
from unintended use or improper handling. The manufacturer/importer reserves
his rights to modify the product any time in order to adjust it to law regulations,
norms, directives, or due to construction, trade, aesthetic or other reasons, without
notifying in advance.