Zelmer AH1001 User Manual - page 37
39
AH1001-001_v01
The direction of unscrewing and screwing is
marked on the underside of the cap of the valve.
4
Fill the water tank with clean water. The maximum water
tank capacity is about 1.7 liters.
Use cooled boiled water or distilled water. The
water temperature should not exceed 40°C.
5
Replace the cap from the valve on the water tank and
turn it in a clockwise direction until the water tank will be
sealed.
The direction of unscrewing and screwing is
marked on the underside of the cap of the valve.
6
Turn the container upside down and mount the water
tank by putting it on the base of the humidifier. Mount the
steam jet on the water tank. Water begins to overflow to the
base of the humidifier.
STARTING THE APPLIANCE
1
Connect the power cord into an electrical outlet.
2
To turn the appliance on, turn the control knob in
a clockwise direction until it clicks. You will see the blue light
on the indicator light, and humidifier begins to emit steam.
Do not operate the appliance if the water tank
is empty.
3
Use the control knob to set the amount of generated
steam (LOW – for low amount; HIGH – for high amount).
4
To switch the appliance off, turn the control knob to the
position
. The indicator light goes out.
AUTOMATIC STEAM SHUT-OFF
The humidifier has an automatic steam off function, which
will be activated in the following cases:
a) If during operation of appliance the water level drops
below the required level, a safety switch automatically
stops the appliance operation, preventing it from
overheating.
Indicator light will flash red-blue, and after
some time you will see the red light. After filling
the tank and placing the appliance on the base,
the appliance will start steaming again. You will
see blue light on the indicator light.
b) During operation, removing the water tank or incorrect
installation of the tank on the base of humidifier will
launch a safety switch that automatically stops the
machine, preventing it from overheating.
You will see red light on the indicator light. After
proper installation of the tank on the base, the
appliance will start steaming again. You will see
the blue light on the indicator light.
D
Suggestion
Information on the product and suggestions
for its use
The appliance is intended solely for domestic use. It
●
is not intended for commercial use, economic, or for
outdoors use.
Before first use, keep a humidifier in the room at room
●
temperature for about 30 minutes.
Technical parameters
The technical parameters are indicated on the rating label.
The appliance features double electrical insulation (Class II)
and does not require grounding.
The air humidifier fulfills the requirements of the existing
norms.
The appliance is in conformity with the requirements of the
directives:
Low voltage appliance (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
–
The appliance was marked by the CE sign on the rating
label.
Structure of the appliance
A
1
Steam jet
2
Water tank
3
Cap with valve
4
Base of humidifier
5
Float switch
6
Ultrasonic transducer
7
Connection cable
8
Fan outlet
9
Control panel
10
Control knob
11
Indicator light
12
Stem for opening the valve
13
Brush
Maintenance and operation
PREPARING THE APPLIANCE FOR
OPERATION
Place the appliance on a dry, flat surface away
from potential heat sources (heating plates/
panels, cookers, ovens, etc.).
1
Remove the steam jet from the water tank.
2
Remove the water tank from the base of the humidifier,
lifting it up. Turn the water tank upside down.
3
Loosen the nut on the valve by turning it counter
clockwise.
B