Zelmer fp1100 User Manual - page 38
44
ZFP1100-001_v02
Tips for speed settings
Control knob
speed setting
Function
Application
1-3
Kneading
Kneading heavy, dense dough, such as yeast dough, pasta dough,
dumpling dough, etc., and to pre-mix the ingredients.
4-8
Mixing
For mixing cake cream, batter, mashed potatoes, etc.
9-12
Whipping
Whipping egg whites, whipped cream, creams, etc.
It features 12 speed settings and an off position "0".
1
In order to operate the appliance, turn the knob clockwise
from "0" (off) to the required speed setting.
To avoid splashing the ingredients out of the
bowl, always start at the lowest speed. When
the ingredients start to mix, you can increase
the speed in accordance with the information
contained in section Tips for speed settings.
When finished, turn the speed control knob
to "0" (off) and remove the plug from the wall
socket.
Using the attachments
WHISK
It is used for whipping egg whites, whipping cream, kneading
light sponge cakes, etc.
FLAT BEATER
It is used for preparing cake cream, batter, mashed
potatoes, etc.
MIXING HOOK
Is used for kneading heavy dough such as yeast dough,
pasta dough, dumpling dough, ginger bread dough, etc.
Mixing time
Your food mixer will mix faster and more thoroughly
than most traditional mixers. Therefore, mixing time
recommended in traditional recipes should be adjusted in
order to avoid excessive mixing. For example, some dough
may require only half the time to get mixed, compared to
traditional food mixers.
Do not operate the appliance continuously for
more than 10 minutes. Allow the appliance to
cool down for at least 20 minutes.
INSTALL THE BOWL
1
Turn the speed control knob to "0" (off). Remove the
plug from the wall outlet.
2
Lift the motor unit rotating head.
3
Install the bowl on the base.
4
Rotate the bowl clockwise until it locks.
REMOVE THE BOWL
1
Turn the speed control knob to "0" (off). Remove the
plug from the wall outlet.
2
Lift the motor unit rotating head.
3
Rotate the bowl counter-clockwise until it unlocks.
4
Lift the bowl and remove it from the base.
INSERT THE ATTACHMENTS (WIRE WHISK,
FLAT BEATER, MIXING HOOK)
1
Turn the speed control knob to "0" (off). Remove the
plug from the wall outlet.
2
Lift the motor unit rotating head.
3
Align the notch at the top of the attachment with the pin
on the rotating head drive shaft.
4
Push the attachment into the shaft and rotate counter-
clockwise until the shaft pin is fully inserted.
REMOVE THE ATTACHMENTS (WIRE WHISK,
FLAT BEATER, MIXING HOOK)
1
Turn the speed control knob to "0" (off). Remove the
plug from the wall outlet.
2
Lift the motor unit rotating head.
3
Rotate the attachment clockwise, until when the pin on
the drive shaft will be aligned with the notch in the whisk/
attachment.
4
Remove the attachment.
SPEED CONTROL KNOB
Planetary food mixer is equipped with a speed control knob.
D
E
F
G
B