Zelmer ts1710 User Manual - page 34
38
TS1710-001_v01
During continuous toasting, subsequently pre-
pared toasts will be more browned than those
prepared in the first cycle.
3
To insert bread into the toaster, slide the lever down until
it locks into position. Toasting cycle will start.
The lever will only lock when the appliance is
connected to the power supply.
The browning degree may be observed dur-
ing toasting. When the bread is sufficiently
browned, the toasting cycle may be stopped at
any time by pressing the STOP button.
4
After the toasting cycle has ended, the lever will auto-
matically slide up to the initial position.
If the bread is not sufficiently toasted, another
toasting cycle may be run. Select light brown-
ing
(adjustment knob in position 1 or 2) and
then push the toasting lever down until it locks
into position. Control the browning degree to
ensure the toasts would not burn.
●
Remove the toasts, be careful not to touch any hot sur-
face.
If bread slices are stuck in the toaster, press
the STOP button and pull out the plug from the
socket. Wait until the toaster cools down com-
pletely and carefully move the bread so that no
heating elements are damaged.
Additional features
FROZEN BREAD TOASTING
Place the frozen bread slices in the bread slots, select the desired
degree of browning. Slide the bread slices down into the toaster
by pushing the lever down until it locks into position and press the
DEFROST button. The button will light up.
Frozen bread toasting takes more time than
thawed bread.
BREAD REHEATING
This toaster enables bread reheating, irrespectively of the
selected browning degree. Place the toasts in the bread slots.
Slide the bread slices down into the toaster by pushing the lever
down until it locks into position and press the REHEAT button.
The button will light up.
Notes on toasting
Toasting is a combination of bread roasting and drying.
Humidity levels vary for different types of bread, which may
cause differences in the time of toasting.
●
For slightly dry bread, use a setting lower than the stand-
ard.
●
For fresh or wheat bread, use a higher setting than the
standard.
●
Bread with a very uneven surface will require a higher
setting.
●
Toasting thicker pieces of bread will last longer, because
before toasting the bread needs to remove more mois-
ture. Very thick pieces may require two toasting cycles.
Cleaning and maintenance of the
toaster
1
Before cleaning, always switch off the toaster, pull out
the plug from the socket and wait until it cools down com-
pletely.
2
To remove the bread crumbs from the toaster, remove
the bread crumb tray located at the bottom of the toaster.
Empty it and place it in the same position as previously.
Do not use the toaster with no bread crumb
tray in place.
3
To remove the bread crumbs from inside of the toaster,
turn the toaster upside down and gently shake the bread
crumbs out.
4
The external surfaces clean with a soft, slightly damp
cloth and wipe dry.
Do not allow excessive accumulation of bread
crumbs in the tray. Bread crumb tray should be
cleaned regularly.
Ecology – Environment protection
Each user can protect the natural environment.
It is neither difficult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to particular disposal
centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose the appliance with the municipal waste!
C