Z-e2026 device installation manual en.
2 compatibility list model model version model year vw polo 6r 2010 – 2014 vw eos 1f from 2006 vw scirocco iii 13 from 2008 vw beetle coupé 5c from 2011 vw beetle cabrio 5c from 2012 vw golf v 1k 2003 – 2008 vw golf v variant 1k 2007 – 2009 vw golf vi 5k 2008 – 2012 vw golf vi variant aj 2009 – 2013...
3 ● the installation of the zenec system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect installation can cause damage to the vehicle and the zenec system. ● correct functioning can only be guaranteed when you use the zene...
1 4 4 3 2 example of installation golf vi removal work and preparation: 3. Unscrew and remove the four torx screws (t25) of the original device. 1. Gently lift the trim frame starting on the right side of oe device. For successful completion of this step, using a release tool made of plastic tool is...
8 5 9 installation: 5. (no picture) fit the gps antenna (no. 3) at a suitable place, and make sure that the gps reception is not adversely affected due to shadowing by metallic vehicle parts (thermal glazing etc.). Next run the connecting cable to the radio slot. 6. (no picture) if you wish to use i...
6 10 11 12 commissioning make sure that the vehicle is located outside, and that the gps reception is not adversely affected by any shadowing (trees, high buildings etc.). Now insert the navigation software sd card (no. 2) supplied into the microsd card slot of the zenec system, and start it in orde...
Technical modifications excepted. No liability granted for print ing errors. © copyright 2015 · reva / copy deadline: q4-2015 · english zenec · bohrturmweg 1 · ch-5330 bad zurzach · schweiz/switzerland · mail: support@zenec.Com · www.Zenec.Com kl 31 / power gnd b12 c15 kl 30 / constant +12v pwr b15 ...
