Z-e2050 device installation manual en.
2 model model version model year vw amarok 2h as of 2010 vw beetle cabrio 5c 2011 – 2015 vw beetle coupé 5c 2011 – 2015 vw caddy 2k/2c 2003 – 2013 vw cc 35 2008 – 2014 vw eos 1f 2006 – 2013 vw golf v 1k 2003 – 2008 vw golf v variant 1k 2007 – 2009 vw golf vi 5k 2008 – 2012 vw golf vi variant aj 2009...
3 ● the installation of the zenec system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect installation can cause damage to the vehicle and the zenec system. ● correct functioning can only be guaranteed when you use the zene...
1 4 4 3 2 example of installation golf vi removal work and preparation: 3. Unscrew and remove the four torx screws (t25) of the original device. 1. Gently lift the trim frame starting on the right side of oe device. For successful completion of this step, using a release tool made of plastic is mand...
5 9 8 installation: 5. (no picture) install the gps antenna (no. 2) in a suitable position, making sure that the gps reception is not adversely affected by unwanted shielding of metallic vehicle parts (thermal insulation glazing, etc.). Then route the connection cable into the radio bay. 6. (no pict...
6 10 11 12 commissioning finally carry out a general functional test and perform the basic and car specific settings (ac, ops etc.). Also ensure that no fault warnings appear on the vehicle side. 12. Press the trim frame back on to make the installation complete. ● make sure that all connectors at t...
Technical modifications excepted. No liability granted for print ing errors. © copyright 2018 · revb / copy deadline: q1-2018 · english zenec · bohrturmweg 1 · ch-5330 bad zurzach · schweiz/switzerland · mail: support@zenec.Com · www.Zenec.Com connection diagram c1 rear monitor out c2 n.A. C3 camera...
