1 z-e6150 installation manual en.
22 compatibility list 1. If your vehicle has a basic factory-fitted radio (similar to the one pictured here), you need to acquire a suitable toyota cover for your vehicle before you can install your z-e6150. 2. If your vehicle has a high-quality factory-fitted radio (as shown here h = 100 mm, b = 20...
3 attention ● the zenec system should be installed by an authorised retailer. Specific knowledge and tools are required for installation. Incorrect installation can damage the vehicle and the zenec system. ● fault-free operation can only be guaranteed if you use the equipment supplied, or the option...
4 example of installation: toyota avensis 3g (type t27) disassembly and preparation: note 1. Remove the ignition key and leave it outside the vehicle for the duration of installation. 2. Start with the uninstallation of the original unit. 3. Do not switch the ignition back on until all the points in...
5 5. Unscrew and remove the four phillips (ph2) or hex (10mm) screws from the original unit. 6. Carefully pull the original unit out of the radio bay. Then unplug all cables on the rear of the unit. 7. Transfer the original radio brackets (left and right) to your zenec system. 8. (no picture) instal...
6 11. Connect the main connection cable (no. 2) of the zenec system (no. 1) to the two radio plugs on the vehicle. Depending on your vehicle, you must use either the 20-pin (no. 3) or the 28-pin connector (no. 4) to operate the aux connector and the steering wheel remote control. You must connect th...
7 15. You must reattach the radio cover once you have fixed the zenec system back into position. Remember to reconnect the plug for the hazard lights to the rear of the radio cover. To finish in- stallation, simply attach the plastic covers to the left and right of the centre console. Note ● ensure ...
8 f3 f2 f1 f b24 b2 b23 b1 g e14 e1 e28 e15 * e c6 c3 c2 c1 c d20 d11 d10 d1 * b b4 b1 b10 b5 d 20 pin connector (device backside) a1 a11 a10 a20 a z-e6150 dab hdmi usb 2 gps ukw/ fm usb 1 connection diagram usb1: • apple mfi • usb media playback - smartlink direct - software updates usb2 • apple mf...
9 e d a g f dab usb 1 usb 2 hdmi 28 pin 20 pin p.Ant b c au x- in r au x- in l au x- in r au x- in l r ev. A na lo g w he el k e y (k e y1 / k e y2 / g n d ) b13 b12 b11 b1 0 b9 b8 b7 b6 b5 b4 b3 b2 b1 b1 5 b14 b17 b1 6 b1 8 “e” or “d” con- nection cable depends on the vehicle!.
Technical modifications excepted. No liability for printing errors. © copyright 2017 · reva / copy deadline: q4-2017 · english zenec · bohrturmweg 1 · ch-5330 bad zurzach · schweiz/switzerland · mail: support@zenec.Com · www.Zenec.Com.
