ZENEC Z-R1030 User Manual - page 23
47
46
Z-R1030
TROUBLESHOOTING
Problem
Cause
Solution
Player does not play disc.
Disc inserted incorrectly.
Reinsert the disc with the label
side up (facing the ceiling).
Disc format is not supported.
Check the disc format.
Disc is dirty or scratched.
Clean or replace the disc.
The player suddenly stopped
working or the screen went black.
Player error.
Try turning the player off and on.
If the player still doesn t respond,
press the reset button.
Player doesn t turn on.
The car ignition (or ACC/
accessory) is off.
Insert the key into the ignition and
turn it to ACC/accessory.
Condensation in the player.
Wait for about one hour or until
condensation evaporates.
Player operates erratically.
Battery needs replacing
Replace the battery.
Dirty IR window on the player or
remote control.
Clean the player s and the remote
control s IR windows.
Loose connections.
Check and tighten all
connections.
Picture skips occasionally.
Disc is dirty or scratched.
Clean or replace the disc.
Blurred picture on the screen.
Interfered by short-distanced
strong interference
(E.g. high voltage wire,
transformation station or
Move the vehicle away from the
Interference.
The picture on the screen is dark.
The equipment locates at a low
temperature area.
This is the characteristics of LCD
display in low temperature, it
will restore to normal brightness
after starting the display for few
minutes.
Brightness is set too low.
Adjust the brightness setting.