Zenith IQC50H94 Technical Training Manual - Product Saftey
4
PRODUCT SAFTEY
Perform the following when the
HV connector (anode connec-
tor) is removed or inserted for
CPT replacement, etc.
During Removal
1. Roll out silicon cover from FBTs contact
area slowly.
2. While turning the connector about 90 de-
grees following the arrow (0 position). Push the
connector slightly toward the case. (Fig. A)
During Insertion
1. Please refer to direction for insertion as
shown in Fig. B (L position). Insert connector
until CLICK sound is heard.
2. Make sure the connector is pressed right in,
so that it has a good contact with the spring.
3. Confirm the contact by pulling the connector
slightly. (Dont pull hard because it may damage
the connector).
4. Cover the high voltage output by carefully
pushing silicon boot onto it. (Dont turn the
connector).
Note: Make sure the silicon boot is covering the
high voltage output.
3. Remove the connector slowly by pulling it away
from the case.
),*$
386+
386+
+9&DEOH
)O\EDFN
7$%
326,7,21
),*%
)O\EDFN
+9&DEOH
%RRW$VVHPEO\
/(667+$1PP
'()/(&7,21
3:%
)%7
$12'(
&211(&725