2easy DT-597 Manual - Door Station Mounting
Lock Control Jumper :
To program electric lock type
Door Station Code DIP :
To program address for up to 4 x door stations
T/R+,T/R- : USB-RS485 communication terminal
Main Connect Port :
To connect the bus line and electric locks (up to 2)
BUS :
Connect to the bus line, no-polarity
PL :
Additional power supply for the lock, connect to the power positive(power +)
S1+ : The first lock power (+) output
S2+ : The second lock power(+) output
S - : Lock power(-) output
Door Station Mounting
OPEN
CLOSE
90°
1
2
3
4
Adjusting Camera Angle
Use a screwdriver to loosen the
screw. Adjust the angle of the
camera and tighten the screw
Steps:
1. Cut out an appropriate size hole, and mount the wall box
2. Adjust the camera angle if needed. Connect the cables. Place name label if required
3. Place the front panel into the mounting box
4. Use the special spanner provided and move it 90
0
to lock the front panel
-3-