2gig Technologies GC2 User Manual - page 19
GC2 Wireless Security System | User Guide
16 Copyright © 2016 Nortek Security & Control
Quick Exit in Away Mode
A programmable option called Quick Exit
may be displayed on the Security screen
while the system is armed in the Away
mode. Tapping the Quick Exit button starts a
timer to allow someone to exit or enter
through a sensor‐protected door
programmed for delay without having to
disarm the entire system. When the delay
timer runs out, the system returns to the
normal Away mode.
TIP: If interior sensors are installed in the
system in certain areas, do not violate
those sensors when using the Quick Exit
feature in Away mode.
Auto Stay Mode
The system may have been programmed by
the installer for Auto Stay mode. If this
option is on and the system is armed in Away
mode, if an exit/entry delay sensor is not
triggered before the Exit Delay expires (no
one leaves the premises), the system
automatically arms in Stay mode instead of
Away mode.
NOTE: Quick options can be turned on
or off by your installer. Refer to
"Installer Programmed Options" on
page 40, to see which options have
been set for your system.
Arming to Away Mode
Use the Away mode to arm the system when
everyone will be leaving the home. The
Away mode normally has an Entry Delay so
someone with a user code can re‐enter
without causing an alarm. Interior and
perimeter sensors are armed in the Away
mode.
1
Close all sensor‐protected doors and
windows before arming.
2
Verify that the
button on the Control
Panel is lit green, indicating that the
system is ready to arm. The Security
button and Arm button on the display
will also be green when all perimeter
sensors are closed. If the
icon is
displayed on the status bar, an interior
sensor is open; be sure to close or
manually bypass the interior sensors or
an alarm will occur.
3
To arm the system quietly without
sounding any announcements, tap the
button before performing the next
steps:
•
At the Arming screen check the
Silent Exit box
Or
•
During the Exit Delay, tap Silence
4
At the Security screen, or the Menu
screen, tap Arm.
NOTE: If any perimeter door or window
sensors are open, the Bypass
screen appears. Close all the
sensors displayed or tap Bypass All
to force bypass the displayed
sensors.
NOTE: Bypassed sensors do not trigger
an alarm.
To bypass sensors, enter a user code
unless the installer has set the system for
Quick Bypass.
5
On the Arming screen, the Entry Delay
check box option can be used with Away
mode.
•
The system can be armed without an
Entry Delay. All perimeter doors trigger
the alarm instantly. The system has to be
disarmed with a wireless key fob. To arm
with all exit/entry perimeter doors as
instant, clear the Entry Delay check box.