2gig Technologies GC2 User Manual - System Test
GC2 Wireless Security System | User Guide
34 Copyright © 2016 Nortek Security & Control
SYSTEM TEST
Even though your security system is self‐
monitoring, it is still important to regularly
test the system manually. The System Test is
used to test each of the sensors in the
system. The master user code is required to
test the system. While the system is in test
mode, a “T” icon blinks on the upper right of
the display.
IMPORTANT: Test your Security System
weekly to ensure continued protection
and proper system operation.
To test the system:
1
At the Home screen, tap Security.
2
At the Security screen, tap Menu.
3
At the Menu screen, tap Toolbox.
4
To access the system test, enter the
master user code.
5
At the Toolbox (1 of 3) screen, tap
System Test.
Sensor Test
When each sensor is tested, the Control
Panel does the following:
•
Beeps and announces the sensor’s name
•
Displays green bar lights by the sensor
name
•
Displays green signal bars to show the
strength of that sensor’s wireless signal
NOTE: Start and stop test reports are
sent to the Central Station.
1
At the System Test: Console screen, a list
of sensors appears. Use the ↑ and ↓
arrows to scroll through the list.
2
Go to each sensor listed, and trigger it.
•
For door or window sensors, open
and close the door or window.
•
For motion detectors, stay out of the
protected area for five (5) minutes,
then walk through the area.
•
For portable sensors and wireless
keypads, tap a button.
•
For smoke, CO, or glass break
detectors, tap the detector’s test
button.
TIP: When a red bar is displayed for a sensor,
the test has failed.
3
When all sensors have been tested,
tap OK. Then continue with the Panel
Test.
Panel Test
The panel test checks the Control Panel’s
indicators and sounder.
1
At the System Test: Console screen, a list
of tests to perform on the panel appears.
Use the ↑ and ↓ arrows to scroll
through the list.
2
Tap each button in the list. Then tap Yes
or No to respond to the test question.
3
After answering all of the questions, tap
OK.