2n officeroute quick guide version 0.91.
2n officeroute basic settings connection of officeroute officeroute has default ip address 10.0.0.1 and mask 255.0.0.0. You can reach officeroute’s web interface in case that you assign ip address of your pc from the same range as ip of officeroute. In case you want to change ip address of officerou...
2n officeroute type ip address of officeroute into your web browser and you’ll get login page:: default login name is admin , no password. Settings for umts router functionality sim card settings before you insert sim card into the unit, it is needed to set pin code (or disable pin code in your mobi...
2n officeroute if pin code is stored, power-off the unit, mount antenna and insert sim card(s). Then power unit on. When led indicators are off, it means that sims are logged into to a network. In case that led indicator shines orange, there’s no signal of preferred network or pin is wrong. Log into...
2n officeroute fill gprs provider name (user defined) and apn (you can find this information on a web page of network provider or ask his help line). Sometimes username and password is needed. Don’t fill gprs number and gprs initial at commands (these settings are not needed for most cases)..
2n officeroute connection to internet save sim card settings. Switch on connection to internet in the section network – gprs on/off by clicking to icon with green handset „gprs“. After cca 30 seconds led indicator starts blinking by green colour – it usually means that it is connected to the network...
2n officeroute settings for sip ip pbx functionality – how to add a new account and call to gsm/umts user settings user management>users>add user: adding of a new user/extension user name: sip authentication name for sip extension. New password: sip authentication password. Rights/rights denied: sel...
2n officeroute his mobile phone number for receiving notification smses. Internal sip line internal sip line connects sip proxy to lcr. You can imagine it as such gateway to lcr – see picture bellow. User ‚vbegw‘ is predefined as default user for internal sip line with password ‘1234’. Modify intern...
2n officeroute where ‚sip server address‘ is ip adres sof officeroute. Set route telephony services>lcr>routes – list of existing routes and adding and removing routes. A route means outgoing trunk (bundle of sims, modules, sip lines or disa lines)..
2n officeroute fig. 1 – ‘add route’ form there is a route named ‘mobile networks’ on the picture which contains all modules, it is being used during all defined time intervals without suppressing cli (cli can be suppressed for mobile networks only). Set lcr lcr rule – routing of call is based on the...
2n officeroute there is an example of a lcr rule. Destination name is user defined, the rule is applied to called numbers with prefixes 6 or 7, call is routed to the route ‘ mobile networks’ with unknown priority. Priority can be according free minutes, first free or cycle (for free minutes and cycl...
