3B LASER PEN 200 Operating Instructions Manual - Using The Laser
Possible settings for the therapy time are:
10 sec.–1 min. in 20-sec. increments
1 min.–10 min. in 1-min. increments
Possible settings for the dose are depending on the specific model and are :
3B LASER 500 / 1 J–60 J max.
Once all laser parameters have been set, this is shown in the display. The different values are now no longer flashing
and you can start with the laser treatment – see the chapter “Using the Laser.”
Please note:
The maximum energy dose rate that can be selected is 60 J.
Example: If the setting is 60 J (dose), laser/power 500 mW and mode CW set, the therapy time is 2 minutes,
and for frequency modes it’s 4 minutes.
Note: Please understand that due to the correlation between energy and therapy time, changing one of the
two parameters will also impact the other parameter. The respective other value will be automatically
adjusted accordingly.
The selected value for the therapy time is confirmed and stored by pressing the SET key (3) again. You can now start
using the laser (see the chapter “Using the Laser”).
Please note that the settings for the parameters are retained when the unit is turned off and on again.
Using the Laser
The laser application can now be activated, if the base setting (display of the parameters) is shown on the screen.
Please note: It is not possible to activate the laser, if a parameter is still flashing.
8 mW
8 J
A
CW
Pressing the LASER key (1) activates the laser after a 2-sec. warm-up period. The LED (6) lights up green and the
display changes to the following screen:
500 mW
4:43 - 8.5J
The display (5) now shows the remaining therapy time and the emitted energy dose rate in Joule as well as the
selected point search mode. The selected therapy time now counts backwards and the energy dose rate changes in
line with the selected laser power and the elapsed therapy time according to the formula “Energy dose rate (Joule) =
Laser power (mW) x Therapy time (sec.)”.
If the loudspeaker has been turned on, a signal will sound every 20 sec.
10
M
Last revised 2017-09-26