3Com 3C421600A Release Note - page 8
8
R
ELEASE
N
OTES
S
UPER
S
TACK
® II R
EMOTE
A
CCESS
S
YSTEM
1500 R
ELEASE
2.0
For example, to set an existing user, “john,” as a “network” type, enter
the following commands in the CLI:
1
disable user john
A message appears.
2
set user john type network
3
enable user john
Installing 3CDaemon
and Adobe Acrobat
from the 2.0
Source CD
Before you install freeware applications, such as 3CDaemon and Adobe
Acrobat, from the 2.0 Resource CD, you must disable any antivirus
software that is running on your system (i.e., Norton Utilities). If you do
not, your system may fail and you may receive an operational failure
message, “ISSET_SE”. If after you disable antivirus software you still
receive an “ISSET_SE” after installing your freeware, go to the Microsoft
Support Web page and search on “ISSET_SE” for installation problems.
North American
Switch Types for
ISDN BRI calls
In rare situations, ISDN BRI calls using North American switch types, may
connect and then immediately disconnect. If this happens, while using
this release, issue the following commands for each of your BRI ISDN
interfaces on the Router Unit or Port Expansion Module (PEM):
set switched interface rm0/slot:1/mod:1 at at*B3=0
set switched interface rm0/slot:1/mod:2 at at*B3=0
set switched interface rm0/slot:1/mod:3 at at*B3=0
set switched interface rm0/slot:1/mod:4 at at*B3=0
set switched interface rm0/slot:2/mod:1 at at*B3=0
set switched interface rm0/slot:2/mod:2 at at*B3=0
set switched interface rm0/slot:2/mod:3 at at*B3=0
set switched interface rm0/slot:2/mod:4 at at*B3=0
Copyright © 2000, 3Com Corporation
3Com, the 3Com logo, and SuperStack are registered trademarks of 3Com Corporation.
Other brand and product names may be registered trademarks or trademarks of their respective holders.