3Com 3CR17450-91 Getting Started Manual - page 24
22
C
HAPTER
2: I
NSTALLING
THE
S
WITCH
To rack-mount your Switch:
1 Place the Switch the right way up on a hard, flat surface with the front
facing towards you.
2 Locate a mounting bracket over the mounting holes on one side of the
unit, as shown in Figure 4.
3 Insert the four screws supplied in the mounting kit and fully tighten with
a suitable screwdriver.
Figure 4 Fitting a Bracket for Rack-mounting
You must use the screws supplied with the securing brackets. Damage
caused to the unit by using incorrect screws invalidates your warranty.
4 Repeat the two previous steps for the other side of the unit.
5 Insert the unit into the 19-inch rack and secure with suitable screws (not
provided). Ensure that ventilation holes are not obstructed.
6 Reconnect all cables.
Montagesatz
Anweisungen
Der Switch wird mit zwei Halterungen und vier Schrauben geliefert. Diese
werde für den Einbau in einen Baugruppenträger benutzt. Bei der
Montage der Baugruppe beachten Sie die Anweisungen aus: “Choosing
a Suitable Site” (Aufstellen des Switch).