3Com 3CR17450-91 Getting Started Manual - page 37
Manually Configuring IP Information
35
To connect to command line interface, follow these steps:
1 At the login and password prompts, enter
admin as your user name and
press Return at the password prompt. If you have logged on correctly, the
top-level menu of the command line interface is displayed as shown in
the example in Figure 8.
Figure 8 Example Top-level Command Line Interface Menu
2 At the Select menu option prompt, you can either:
■
Enter the
protocol ip basicConfig command. At the Enter
configuration method prompt, enter manual. The screen
prompts you to enter the IP information.
or
■
Enter the
gettingStarted command. At the Enter
configuration method prompt, enter manual. The screen
prompts you to enter the IP information.
3 Enter the IP address, subnet mask, and gateway IP address for the Switch.
The screen displays a summary of the information entered.
If using the
gettingStarted command, you will then be prompted to
enter system information or to change passwords, and then given the
option to carry out advanced configuration.
The initial setup of your Switch is now complete and you can now set up
your chosen management method. See “Methods of Managing a
Switch” on page 39.
If you do not intend to use the command line interface via the console
port to manage the Switch, you can log off, disconnect the serial cable,
and close the terminal emulator software.
Menu options: -------3Com SuperStack 3 Switch 3870 48-port--------
bridge - Administer bridge-wide parameters
feature - Administer system features
gettingStarted - Basic device configuration
logout - Logout of the Command Line Interface
physicalInterface - Administer physical interfaces
protocol - Administer protocols
security - Administer security
system - Administer system-level functions
trafficManagement - Administer traffic management
Type ? for help.
-------------------------------- (1)------------------------------
Select menu option: