3Com OfficeConnect 3C3SH654B User Manual - page 32
26
C
HAPTER
5: W
INDOWS
NT
Consult with your MIS representative if you do not know what settings to use.
Once the procedure is completed, reboot for the changes to take effect.
Installing the Modem
For instructions on installing the modem, see “Installing the Modem Interface” on
page 28.
Setup Using System
Soft Software
For setup using System Soft Card and Socket Services:
1 Insert the LAN+Modem card and connect to the network as described in
“Installing and Connecting the Card” on page 1. The system will find the card and
display a PCMCIA Card Not Configured dialog box.
2 Click Correct. The card wizard for Windows NT will appear with instructions for
installing the card.
3 Click OK and continue with the procedure described for “Setup Using Point
Enabler” below.
Setup Using Point
Enabler
Point-enabler installation is a basic, manual installation procedure that will work
on nearly all configurations, including systems with System Soft Card and Socket
services installed. If you are running the Softex software on your system, use the
procedures for “Inserting the PC Card and Running the Installation” on page 25.
Installing the Network
Interface
Before installing the network interface, insert the LAN+Modem card and connect
to the network as described above. Obtain the following information from your
MIS department:
■
For Windows NT networking, your computer name and workgroup or
domain name.
■
For your network account, your user name and password.
The LAN+Modem card requires that Service Pack 3 (or a later version) be installed
on your computer. Contact your network administrator or Microsoft if you do not
have Service Pack 3 or later.
Setup With No Networking Installed
This procedure assumes that you have not already installed Windows NT
networking on your notebook computer. If networking is installed, see “Setup
With Networking Already Installed” on page 27.
1 In the Control Panel, double-click Network.
2 When the system prompts: ”Windows NT Networking is not installed. Do you
want to install it now?”, click Yes. This opens the Network Setup Wizard.
If the Network Setup Wizard does not appear, refer to “Setup With Networking
Already Installed” on page 27.
3 Check Wired to the network and click Next.
4 When the system prompts to have setup start searching for a network adapter,
click Select from List.
5 Click Have Disk. Put the LAN+Modem card Installation CD (disk) in the floppy drive
and click OK.